Aluminum Casting Plant

In tilting reverberatory type furnaces, raw materials (ingots, ingots and intermediates) are melted up to a certain temperature for certain periods of time.
After the desired tonnage is ready, a sample is taken from the homogeneously mixed liquid metal and its chemical composition values ​​are determined on
the Arl Metal Analyzer spectrometer device. Alloying process (SI, Mn, Mg, Cu, Mn, Cr) is performed on the liquid metal until the chemical composition is obtained.
After the desired alloy content is obtained, the pre-refining process is completed by cleaning the slags along with the degassing process in the liquid aluminum
by using a special method, Slag forming flux, together with nitrogen gas. The liquid metal, which is ready for casting in terms of temperature and analysis,
passes through the runner and reaches the casting table after passing through the Sıvex Lp Grade 40 filter. Casting parameters (casting speed, water flow rate,
water temperature, metal temperature, etc.) are entered using the PLC program and casting begins. Billets are produced in the diameters requested by the customer.